Transition notes: The materials used in this lab are mostly the same as Lab 10. Note the following exceptions:

1. The component bag needs to be switched.
2. The SPDT switch is put away.
3. The Power supply is not used and should be placed back on the shelf.
4. Item 8, a large wire-wound inductor needs to be put out.

Equipment List:

1. Tektronix TDS 1002 Oscilloscope
2. BK Precision 4017A Function Generator
   • 1- BNC tee (attached to the output of the function generator.)
   • 1-BNC – BNC cable (C26.H)
   • 1-BNC – banana plug cable (C28.H)
   • 1-BNC-Alligator clip cable (C27.H)
3. LCR meter (BK Precision 875B) (C27.3)
4. 1-Manual Range Digital Multimeter (DMM) (C26.3) with black (C23.H) and red (C24.H) test leads
5. Pasco EM-8656 AC/DC Electronics Laboratory (C26.1)
6. Components: (in Ziploc bag) (C26.2)
   •  1 kΩ resistor
   • 0.27 μF capacitor
7. Several wires of varying lengths (5, 10, and 25 cm) (in Ziploc bag) (C26.2)
8. Large wire-wound inductor.(C28.4)
9. Banana plug cables
   • 3-red (C21.H)
   • 3-black (C22.H)
   • Four red and four black banana plug to alligator clip adapters (B2.3)

Notes and tests:

1. Turn on the oscilloscope and check that the "OpenChoice" software can read data from the oscilloscopes.